Peg-Perego VIAGGIO 2-3 SHUTTLE PLUS Instrucciones De Uso página 30

How to secure your child
on a Viaggio 2/-3 Shuttle
Plus car seat without a
backrest
19• Strap the child in as in the figure,
ensuring that the seat does not move
during this operation.
20• Fasten the seat belt, ensuring that
it clicks into place. Position the two
parts of the seat belt as shown in
figure; both the waist and shoulder
straps must pass under the armrest.
21• To complete the installation
process into the car, the adjustable
shoulder loop can be used. To
remove the loop from its location
under the fabric of the seat, follow the
instructions below.
22• Remove the strap from the loop
under the car seat.
23• Extend the strap for the shoulder
loop by pressing the button located
behind the car seat (1) and pulling it
upwards (2).
24• Insert the seat belt into the
shoulder loop (as in the box), then
lower the shoulder loop (1) by pulling
the belt (2).
25• The correct height of the shoulder
loop is just above the shoulder level.
How to remove the fabric
lining
The fabric elements of Viaggio 2-3
Shuttle Plus may be removed for
cleaning.
26• Follow the washing instructions
on the seat's lining.
REMOVE THE LINING FROM THE
SEAT:
27• Unbutton the buttons on the side
of the seat and pull out the seat.
28• Hook the two elastics at the sides
to the base of the backrest.
29• Unbutton the two buttons and
pull off the lower back protection.
REMOVING THE LINING FROM
THE BACKREST:
30• Remove the four eyelets from the
plastic buttons on the sides of the
backrest. To facilitate this operation,
widen the side wings
31• Release the two upper elastics and
the two lower ones located on each side.
32• Remove the two flaps from their
slots on the upper part of the backrest.
To facilitate this operation, raise the
headrest. At this point you can remove
the lining from the car seat's backrest.
REMOVING THE LINING FROM THE
HEADREST:
33• To remove the plastic cover on the
back of the headrest, unfasten the two
side hooks.
34• Release the bottom (1) and top (2)
as shown.
35• To remove the headrest lining, slightly
raise the headrest and release the two
elastics on one side (fig_a) and then on
the other (fig_b). Remove the lining.
How to cover the car seat
Proceed to perform the operations
shown in figures 26 through 35 in
reverse order.
- 30 -