Cortex MIX-R1U Guia De Funcionamiento página 7

STEP ONE
The MIX-R1U features a wide variety of output choices depending
on your requirements, all outputs can be used simultaneously.
Connect either the XLR type (BALANCED) audio output or the
1/4" type (UNBALANCED) audio outputs as well as the RECORD RCA
type (UNBALANCED) audio outputs to a suitable source
(see diagram below).
MIC
OUTPUTS
STEP THREE
After you have connected all the inputs and outputs properly you
may then connect the AC CORD to the DC Inlet, found on the rear
and turn on the unit.
STEP TWO
The MIX-R1U has the ability to accept up to two
analog sources. The input section consists of 4 analog RCA inputs,
labeled PHONO 1/LINE 1, LINE 2, PHONO 2/LINE 3 and LINE 4.
When used together with the Line/Phono switch on each channel,
these can accept either a line level source (CD Player, Cassette
Deck) or a Turntable with a Magnetic Cartridge. Set the switch to
LINE if you wish to connect a Line Level source. Set the switch to
PHONO if you wish to connect a Phono level Source. You may also
connect a second microphone to the 1/4" MIC 2 input.
NOTE: BOTH MICROPHONES WILL BE CONTROLLED BY THE SAME LEVEL ROTARTY ON
THE FRONT OF THE MIX-R1U.
INPUTS
Using the MIX-R1U
Preparing for Use
Connections
CUE
6