Fumis WiRCU Manual De Usuario página 42

^ekor 5
Configure the WiRCU module by following the procedure below:
- Enable the WiFi option on your smart device
- Run the Fumis APP
- Read the WiRCU end user licence agreement and confirm it (if you agree)
The Fumis APP asks you ''Have you already connected the heating device to your WiFi?''
- Select ''No''
- After selecting ''No'', the Fumis APP asks you to enter the password of your WiFi
- Type the password of your WiFi, press the ''WiFi'' button on the WiRCU module
(the WiFi LED starts flashing quicker) While the WiFi LED is flashing quickly, touch the ''Start WiFi
setup'' icon on your smart device.
The connection process may take a few moments
(the connection is established when the WiFi LED is permanently ON and the Status LED starts flashing).
- When the WiFi LED is permanently ON and the Status LED flashes, touch the ''Stop WiFi setup'' icon on your
smart device.
- After touching the ''Stop WiFi setup'', press the ''navigate back'' button on your smart device and the Fumis
APP
will ask you to enter the MAC address and PIN code (located on the sticker on the Fumis WiRCU module).
- Enter the MAC address and PIN code and proceed with ''Step 6'' (shown on next picture)
before confirming them by touching the ''Connect'' icon!!!
^ekor 6
KONTOLOR NA
UREDOT ZA GREEWE
Povrzete go Fumis mod uo so napravata za greewe, koristej} i
go dostaveniot kabel. Povrzete ja ednata sterna od kabelot vo "KONTROLOR"
42
konektorot na Fumis a drugata strana vo vtoriot konektor odelnikot Po~ekajte
^ekor 6
DISPLEJ
KONTOLOR NA
UREDOT ZA GREEWE
Povrzete ja ednata sterna od kabelot vo "KONTROLOR"
Po~ekajte site svetilki da se postojano VKLU^ENI.
Potoa doprete ja ikonata"Povrzi" na va{ata pametna naprava.
DISPLEJ
Povrzete go Fumis WiRCU
modulo so napravata za greewe,
koristej}i go dostaveniot kabel.
konektorot na Fumis WiRCU a drugata
strana vo vtoriot konektor od razdelnikot