Publicidad
Idiomas disponibles
Idiomas disponibles
Anleitung DF 850 AlphaTools
GB
1. Layout
1 ON/OFF switch
2 Set screw for angle adjustment
3 Set screw for height adjustment
4 Setting wheel for cutting depth
5 Additional handle
6 Adapter for dust extraction system
7 Dust bag
8 Face spanner
9 Locking knob for changing the cutter
10 Base plate
11 Angle fence
12 Drive motor
2. Items supplied
DF 850
Case
Adapter for dust extraction system
Dust bag
Tape measure
Face spanner
3. Technical data:
Voltage:
230 V ~ 50 Hz
Power rating:
Idling speed:
11,500 rpm
Cutter dimensions:
ø 100 x ø 22 x 4 mm
Cutting depth:
max. 19 mm
Angle settings:
Protection class:
Sound pressure level,
LPA 95 dB(A)
Sound power level,
LWA 107 dB(A)
Vibration a w
Weight:
4. Proper use
The biscuit jointer is designed for cutting slots for
biscuit joints in solid wood, plywood and
particleboard. The machine may only be used for this
purpose. Any other use than that which is considered
proper is deemed as improper use. The user /
operator and not the manufacturer will be liable for
any damage or injuries of any kind caused as a result
of this.
5. Important information
Please read the directions for use carefully and ob-
serve the information provided. Make yourself
8
24.05.2004
14:13 Uhr
familiar with the machine, its correct usage and the
safety instructions by reading this manual before you
use the tool for the first time.
Safety regulations
Important! The following basic safety action must be
taken when using electric tools to protect the user
from electric shocks and the risk of injury and fire.
Keep these instructions in a safe place. The attached
booklet contains additional safety instructions.
Do not remove sawdust and chips whilst the
machine is operating.
Do not use the machine with abrasive wheels or
circular saw blades.
Protect the disk cutter from shocks and blows.
Only use disk cutters that are undamaged and
sharp, since otherwise the workpiece may splinter.
Before you start work, inspect the disk cutter for
signs of damage. Do not use any bent, torn or
otherwise damaged disk cutters.
Make sure that the workpiece has been carefully
positioned and clamped. Keep your hands away
from the area you wish to machine.
Only hold the jointer by its handle.
Make sure that you can screw the disk cutter on to
800 watts
the drive spindle with an adequate number of
turns.
Make sure that the disk cutter is absolutely se-
cure. Do not use any washers or other equipment
to improve its position when you fit the disk cutter.
0° - 90°
Only move the disk cutter against the workpiece
II /
with the machine switched on.
Always hold and guide the machine with two
hands when working and make sure that you have
a firm standing position.
< 2.5 m/s
2
People under the age of 16 must not use the
3.2 kg
machine.
Wear safety goggles and ear guards when using
the machine. If necessary wear an apron and a
helmet.
You must disconnect the plug from the mains sup
ply before starting any work on the machine. Only
connect the plug to the mains supply with the
machine switched off.
Keep the connection lead away from where you
are working; always put it to your rear.
Do not slow down the disk cutter with your hand
after you have switched off the machine.
The machine must not be operated with the disk
cutter exposed
Seite 8
Publicidad
