VOX Amplification AC30 BRIAN MAY LIMITED EDITION Manual De Usuario página 5

9. BOOST ON/OFF switch
10. BOOSTER FOOTSWITCH jack
11. Mains Input
12. Mains Fuse
Power Output:
Internal speaker:
Power supply:
Power amplifier:
Pre-amplifier:
Input Boost Circuit:
Mains input:
Dimensions:
Weight:
Included items:
Appearance and specifications of this product are subject to change without notice.
URL = http://www.voxamps.co.uk
ON enables the use of the BOOST circuit (and allows for footswitch control
(10)). OFF (BYPASS) disables the use of the BOOST circuit (and footswitch)
completely.
This jack provides connection to use the supplied VOX VF001 single
footswitch (VOX VF001). The LED indicator glows RED when the BOOST
circuit is active, and is OFF when the BOOST circuit is bypassed.
This is where the supplied, detachable Mains (power) cord is connected.
The specific mains input voltage rating that your amplifier needs to run at
is located on the rear panel of your amplifier. Before making any connec-
tions or powering up the amplifier, make sure the correct voltage is set. If
you have any doubt, refer to your local VOX dealer.
This fuse provides an overall safety protection in the event your amplifier
develops and electrical fault. The correct value of the fuse is located on the
rear panel of your amplifier and should only be replaced with one of the
same value.
Specifications
30 Watts RMS into an 16 ohm loudspeaker load.
2x 8 ohm 12", 15 Watt VOX/Celestion AlniCo Blue.
GZ34/5AR4 rectifier, modified AC30 power supply circuit.
12AX7/ECC83 Phase Splitter (inverter), 4x EL84/6BQ5 push-pull cathode
biased, producing a minimum of 30 Watts RMS into a 16 ohm loudspeaker
load, switchable to 15 Watts RMS.
12AX7/ECC83 modified AC30 "Normal" channel circuit.
High Mid/Treble (boost approx 46dB)—discrete transistor circuit – remote
footswitch operation.
preset 100V or 120V or 230V or 240 V ~ 50 or 60 Hz depending on country
of sale. Please see Rating Plate on rear of amplifier for exact specification.
705 x 540 x 265 mm / 24" x 21.25" x 10.4" (W x H x D)
33.5 kg / 73.85 lbs.
Power cable, VF001 footswitch, dust cover.
5