ARDES ARM8P03 Instrucciones De Uso página 16

the pre-filter indicator light will be lit up (red) to remind you to replace
the pre-filter; when the cumulative working time of the machine reaches
3000 hours, HEPA filter indicator light will be lit up (red) to remind you to
replace the HEPA filter.
Replace the prefilter/HEPA filter following the instruction on
"MAINTENANCE". Once the pre-filter/HEPA filter has been replaced
press and together for 3 seconds to reset the timing of the filters.
The related indicators light will be off in the control panel.
8. UV light button
The unit is provided with UV light and photocatalyst that help to remove
germs and bacterias. Press the button to actvate this function; the related
indicator light will turn on in the control panel. Press again this button
to deactivate this function: the related indicator light will turn off in the
control panel.
Maintenance
GB
Disconnect the plug from the socket and let the appliance cool
down well before cleaning it.
This appliance does not require any special maintenance.
In order to clean the appliance, use a soft and dry cloth.
To clean the bottom cover frm the dust, use a soft and slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from
entering into the appliance and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Pre-filter/HEPA filter replacement:
this operation is necessary every time the filter indicator light turns on in
the control panel (approximately every 1500 hours of use for pre-filter
and about 3000 hours of use for HEPA filter).
Pull out the air inlet grid by pushing the closing/open clip.
Take out the HEPA filter and or pre-filter and replace with new one.
Replace the inlet grid.
Follow the insctruction in "INSTRUCTION FOR USE - Filter change" to
reset the pre-filter/HEPA filter time.
16