Troubleshooting; Technical Specifications - Perel Tools WLS552 Manual Del Usuario

Clean the dipstick and insert it into the tank. Check the oil level if necessary. Make sure the oil level is between the
two marks on the dipstick.
Re-install the seal. Be careful not to damage the threads of the aluminium oil tank cover. Dispose of the oil according
to the local regulations.
• Transporting the Log Splitter
Unplug the log splitter from the mains and let it cool down. Move the log splitter using the handle. If it has to be
transported over long distances, make sure to install the log splitter on a flat and non-slippery surface. Fasten the log
splitter if necessary. Recommended transportation temperature: -25°C ~ +40°C.

5. Troubleshooting

Problem
Log fails to split
Log pusher advances with jerks or
strong vibrations
Oil leaks

6. Technical Specifications

Electrical Motor
Voltage
Protection Class
Power
Rotation Speed
Splitter Data
Max. Length of Travel
Max. Splitting Force
Oil Tank Capacity
Splitter Capacity
Max. Diameter
Min. Diameter
Max. Length
WLS552
Cause
Incorrect positioning of the log
Log exceeds permitted dimensions
Wedge does not cut
Oil leak
Hydraulic pressure too low
Air in hydraulic pump
Leakage from the tank
240VAC/50Hz
IP54
1.5 kW
2,850 RPM
375mm
5t
3.7l
250mm
50mm
520mm
8
Possible Solution
Position log correctly
Pre-cut log to meet dimensions
Sharpen wedge
Locate oil leak, contact your dealer
Check oil level and refill if necessary
Make sure the bleed screw has been
loosened
Worn seals, contact your dealer
PEREL