Functions; Power Button - Duux Mistral Manual De Instrucciones

3. Functions

Note: See product overview (chapter 1) for
reference.
1
Control panel
Use the control panel to adjust the settings.
Hygrostat button
Press to increase the desired humidity with
intervals of 5% for each press. The hygrostat
can be set from 40- tot 80% RH (relative
humidity). When the set humidity dissapears, the
display shows the ambient humidity in the room.
Note: When disconnecting the power cable, the
hygrostat setting will automatically reset to factory
pre-set.

Power button

Switch the device on and off by pressing this
button.
Status indicator LEDs
• Running – indicates the device is extracting
moisture. When the ambient humidity reaches
below the set humidity, the running status
indicator will turn off to save power.
Attention: If the running status indicator is
blinking, it means that the ambient temperature is
below 0⁰C or above 40⁰C. Please adjust temperature.
Full – this indicator will light up when the water
•
tank is full or removed from the device. Please
empty the water tank or place it in proper
position.
.
• Defrost – indicates the device is defrosting.
Note: If the defrost indicator is blinking, it means
the humidity and/or temperature sensor(s) are cut
off or made short circuit.
Timer button
Use this button to activate timer modes.
Press once – activate 2 hour time-out (2hr timer
1
indicator LED will light up);
Press twice – activate 4 hour time-out (4hr timer
2
indicator LED will light up);
Press three time – activate 8 hour time-out (8hr
3
timer indicator LED will light up);
Press four times – deactivate timer.
4
9