Electrical Connection - Pinguino F150RH Instrucciones De Uso

5751008400 EX 30-07-2002
Turning on and Selecting functions

ELECTRICAL CONNECTION

Before inserting the plug
• the mains supply corresponds to the
power supply shown on the rating plate;
• the socket and the mains lead correspond
to the power requirements of the applian-
ce;
• the socket is suited to the plug, otherwise
have the socket replaced;
• the socket is properly earthed. The manu-
factures cannot be held responsible for
any damages due to failure in following
normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.
AIR CONDITIONING FUNCTIONS
With the unit turned off, the function selector
9
is in the " " position. To turn the unit on in
air conditioning mode, proceed as follows:
1. Rotate the function selector knob clockwi-
se:
• Place the large crystal symbol
with the reference mark to operate the
unit in air conditioning mode at maximum
fan speed.
• Place the small crystal symbol
with the reference mark to operate the
unit in air conditioning mode at minimum
fan speed.
2. Now set the required temperature by rota-
ting the room thermostat knob
Note
The temperature is not expressed in degrees.
We therefore recommend rotating the room
thermostat dial to the maximum cool posi-
tion. When room temperature has reached
the required level, rotate the thermostat dial
SLOWLY clockwise until the thermostat is acti-
vated, turning the unit off. This programs the
unit to the precise level of comfort required
which will then be automatically maintained
by the thermostat with considerable energy
savings. When regulating the thermostat, the
air conditioning function is temporarily inter-
rupted and the unit continues to operate in
fan only mode.
Note: cool air is discharged from grill
after a delay of three to five minutes.
18
7:50 Pagina 18
7
check that:
in line
in line
15
.
1
only
THIS UNIT EMPLOYS AN EXCLUSIVE CON-
DENSATION RECYCLING SYSTEM TO DISPO-
SE OF EXCESS MOISTURE. IN NORMAL
CONDITIONS, CONDENSATION IS DISPO-
SED OF AUTOMATICALLY. WHEN THE HUMI-
DITY IS PARTICULARLY HIGH, AN EXCESS OF
CONDENSATION MAY BUILT UP IN THE TANK
. WHEN THIS HAPPENS, THE INDICATOR
5
LIGHT 14 COMES ON INDICATING THAT
THE TANK SHOULD BE EMPTIED. ONLY FOR
SOME MODEL: WHENEVER CONDITIONS OF
HIGH HUMIDITY MAKE THE PROBLEM
RECURRENT, YOU MAY DISCHARGE THE
EXCESS WATER DIRECTLY INTO A DRAIN,
USING A RUBBER TUBE WITH AN INTERNAL
DIAMETER OF 12 MM; THE TUBE SHOULD BE
INSERTED INTO THE HOLE PROVIDED, AFTER
HAVING REMOVED THE RUBBER STOPPER.
(see figure below).
MAKE SURE THE TANK IS PUT BACK COR-
RECTLY OTHERWISE THE LIGHT
REMAIN ON.
HOW TO VENTILATE
If you want to ventilate the room only, rotate
9
the function selector
• Place the large symbol
reference mark to operate the unit in venti-
lation mode at maximum fan speed.
• Place the small symbol
reference mark to operate the unit in venti-
lation mode at minimum fan speed.
WILL
14
anticlockwise.
in line with the
in line with the