Turning On/Off - Pur Line HOTI OR 1500 D Manual De Usuario

EN

TURNING ON/OFF

- Press the power switch on the side of the unit to the "ON" position to power the unit. The power
symbol will illuminate on the display.
- Press the "ON/OFF" button on the control panel or remote control. The unit will start to operate
at the High heat setting.
- Press the "ON/OFF" button to stop operation and put the unit into standby mode.
- Press the power switch to the OFF position to turn off the power to the appliance.
SELECTING A POWER LEVEL
Press the "HEAT" button repeatedly to select a Heat level between Low, Medium and High. The
display will show the currently selected Heat level
SETTING THE TEMPERATURE
The desired temperature can be set between 15°C and 35°C. Once the desired temperature has
been reached the unit will stop the heating function.
With the unit operating at the desired heat level use the + and - buttons to set the desired
temperature.
While the unit is heating, the thermometer symbol will flash.
When the room temperature is above the desired temperature the thermometer symbol will be
illuminated constantly.
TIMER BUTTON
The in-built timer will allow you to set the unit to turn on or turn off after a set period of time.
ON TIMER
– The timer will turn on the unit automatically after the time set has elapsed.
1. With the unit turned off, press the TIMER button, then set the number of hours' time you desire
the unit to start by repeatedly pressing the TIMER button.
2. Once the set time has elapsed, the unit will turn on automatically.
3. Press the POWER button before the time has elapsed and the unit will turn on as normal and the
timer will be canceled
OFF TIMER
– The timer will turn off the unit automatically after the time set has elapsed.
1. While the unit is operating, press the TIMER button then set the number of hours' time you desire
the unit to stop by repeatedly pressing the TIMER button.
2. Once the set time has elapsed, the unit will enter standby automatically.
3. Press the POWER button before the time has elapsed, the timer will be canceled and the unit
will turn off.
The heater has two different setup modes, Quick Connection and AP (Access Point). The quick
connection is a quick and simple way to set the unit up. The AP connection uses a direct local Wi-Fi
connection between your phone and the heater to upload the network details.
When first turned on using the switch on the rear of the unit, the power indicator will flash rapidly,
showing that the unit is in Quick connection mode, and ready to set up.
Please ensure your device is in the correct Wi-Fi connection mode for the connection type you are
11