How To Use The Remote Control - EYENIMAL RT 450 Manual De Instrucciones

● Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new remote control from the EYENIMAL range
(Ref. Coding procedure).
● How to use the remote control
The 450 Remote Trainer remote control is designed to operate with 1 or 2 receiver collars.
Before sending any training instruction (beep sound or static correction), you have to select the dog you want to send a message to (dog A =
black collar / dog B = yellow collar).
In order to select the dog, press the A or B key on the remote control (the letter A or B will appear on the LCD screen).

button: beeper
If you press the button, the receiver collar will emit beep sounds. There is no time limit for this function: the collar will continue to beep for as
long as the button is pressed.
It's up to you to use the beep sounds depending on the way you want to train your dog.
With the beep sounds you can:
- send a warning to your dog when he is disobedient,
- draw its attention ...
It's very important to always use the beep sounds in the same way in order not to disturb your dog.

F button: flash static correction
Press the F button to send a warning to your dog using static corrections transmitted by the two contact points located on the receiver collar for a
defined length of time of less than one second.

C button: continuous static correction
Press the C button to send a warning to your dog using static corrections transmitted by the two contact points located on the receiver collar, this
will last for as long as the button is pressed but limited to 8 seconds maximum.

B button: booster button
Press the B button to stop your dog instantaneously.
You can choose the level of static correction you think to be the best for an immediate effect. As a result, you do not need to press the "+" button.
Those static corrections are transmitted by the two contact points located on the collar for as long as the button is pressed but no more than 8
seconds max.
The static correction level selected thanks to the Booster button can be different for each collar.
Programming the Booster button for the A collar (black strap):
- Press the A button for approximately 5 seconds until the static correction level flashes on the LCD screen.
- Press the "+" or "-" button to modify the static correction level.
- Press the A button to confirm the level selected.
Renew the same procedure to program the Booster button for the B collar (yellow strap).

"+" and "-" buttons: static correction level control buttons
Use the +/- buttons for rapid adjustment of the level of static correction of the receiver collar.
15 levels of static correction are available.
Level 1: very weak static correction – Level 15: strong static correction
Always start with the lowest level of static correction.

Back-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off red button
second).
● Checking/replacing battery of remote control
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be prepared to replace the battery.
- 5 -
located on the remote control (approx. ½