General Notes On Operating The Blind; Rollerblind Powered - Domestic AP Remote Instrucciones De Montaje

Operation
5.2

General notes on operating the blind

To operate the blind proceed as follows:
➤ Press the
button to stow the blind.
➤ Press the
button the deploy the blind.
➤ Press the
button to stop the blind moving.
To operate a Venetian blind proceed as follows:
➤ Press the
button briefly to tilt the slats up.
➤ Press the
button briefly to tilt the slats down.
➤ Long press the
➤ Long press the
➤ Press the
button to stop the blind moving.
5.3

Rollerblind Powered

Proceed as shown:
• Pairing or un-pairing the blind to AP Remote: fig. 3
Note: Ensure only the blind being paired is connected to the power supply and
any other blind is disconnected.
• Changing the direction of blind: fig. 4
Note: Un-pair or disconnect from the power supply any other blind on the same
channel. After changing the direction of the blind reconnect or re-pair those
blinds.
• Setting the top and bottom stops: fig. 5
Notice: To define the top and bottom position, respectively:
Press the button at the required top position.
Press the button at the required bottom position.
• Operating the blinds: fig. 6
• Changing the motor speed: fig. 7
Note: The motor has two speed settings: Unrestricted and slow. When unre-
stricted the motor speed will depend on the supply voltage and supply cable
lengths. When set to slow the motors on different blinds will operate at the same
(lower) voltage and will be more consistent.
4
button to stow the blind.
button the deploy the blind.
AP Remote
EN