TESY ES/GCVM 50 EC Instrucciones De Uso página 22

INSTRUCTIONS FOR USE AND STORAGE
EN
Dear Customers,
TESY's team would like to congratulate you on your new
purchase. We hope that your new appliance will bring
more comfort to your home.
The purpose of the technical description and operation
manual is to acquaint you with the product and the
conditions of its proper installation and use. These
instructions are also intended for qualified technicians
who will perform the initial installation or disassembly
and repairs in the event of a breakdown.
Please consider that adherence to the present
instructions will primarily be of interest to the consumer,
but along with this, it is also one of the warranty
conditions, specified in the warranty card, so that the
consumer can benefit from the free warranty services.
The producer is not responsible for damages of the
appliance resulting from operation and/or installation
which are not in compliance with the instructions in this
manual.
The electric water heater conforms to the requirements
of EN 60335-1, EN 60335-2-21.
I. INTENDED USE
The appliance is intended to supply hot water to
households equipped with a piping system with
pressure below 6 bar (0.6 Mpa).
It is designed to operate only in closed and heated
premises where the temperature is not lower than
4°C and it is not designed to operate in a continuous
protracted regime. The appliance is designed to
operate in regions where the water hardness is not
more than 10°dH. If it is installed in a region where the
IMPORTANT RULES
III.
•
The water heater must be mounted only in premises with normal fire
resistance.
•
Do not switch on the water heater unless you have ensured that it is
filled with water.
•
Only qualified plumbing specialists and electricians must perform
the connecting of the water heater to the water and electric mains
(for models without power cord with a plug). A qualified technician is
a person who has the competence according the regulations of the
country in question.
•
Upon connecting the water heater to the electric mains care must be
taken to correctly connect the safety lead (for models without power
cord with a plug).
•
If it is likely for the temperature in the room to fall below 0°C, the
water heater must be drained (follow the procedure described in
section V, subsection 2 ''Water heater's piping connection"). For
22
Instructions for using the built-in wireless communication module (Wi-Fi)
water is harder, it is possible limestone precipitation
to accumulate very fast. This can cause specific noise
during heating, as well as fast damaging of the electrical
part. For regions with harder water yearly cleaning
of the limestone precipitation in the appliance is
recommended, as well as usage of not more than 2 kW
of heating power.
II. TECHNICAL PARAMETERS
Nominal volume, litres - see the appliance's rating
1.
plate
Nominal voltage - see the appliance's rating plate
2.
Nominal power consumption - see the appliance's
3.
rating plate
Nominal pressure - see the appliance's rating plate
4.
This is not the water mains pressure. This is the
pressure that is declared for the appliance and
refers to the requirements of the safety standards.
Water heater type – closed type accumulating water
5.
heater, with thermal insulation
Inner coating – for models: GC – glass-ceramics; SS –
6.
stainless steel; EV – enamel
Daily energy consumption – see Annex I
7.
Rated load profile – see Annex I
8.
Quantity of mixed water at 40°C V40 in litres – see
9.
Annex I
Maximum temperature of the thermostat – see
10.
Annex I
Default temperature settings – see Annex I
11.
Energy efficiency during water heating – see Annex I
12.