Technical Data - Swingline Style+ Manual De Instrucciones

CAUTION:
Do not shred continuously for more than 3 minutes. When the motor has
overheated, the thermal safety switch will start working automatically. If the
thermal switch trips, do not use the machine for about 30 minutes while the
thermal sensitive safety switch cools down so the shredder can be safely
used again.
Emptying the pull-out waste bin (fig 4)
Empty the shredder bin when the shredder paper is visible through the viewing
window on the side of the pullout bin.
1. Pull out the shredder bin (fully).
2. Empty the shredder bin into a waste sack.
3. Push the shredder bin back in ensuring it is fully closed.
CAUTION:
• This machine is not a toy. Keep away from children and pets.
• For indoor use only.
• Never insert fingers into the entry slot of the shredder.
• Turn the power off immediately if your hair, tie or sleeve becomes
entangled in the shredder.
• The shredder bin must be fully pushed closed for the machine to
operate.
• E mpty the shredder bin when it is full otherwise the shredder's perfor-
mance will be adversely affected. Operating the shredder with
a full shredder bin can result in paper jamming in the cutters, which
will increase the machine's noise level.
• Do not force down shredder paper in the bin using your feet.

Technical data

Model
Cutting Type
Shred Size
Sheet Capacity @ 80 gsm paper
Sheet Capacity @ 75 gsm paper*
Entry Width
Product Dimensions
Rated Voltage/Frequency
Rated Current
* 8.5" x 11", 20lb., (75g) paper at 120V, 60Hz, 3 Amps; heavier paper,
humidity or other than rated voltage my reduce capacity.
6
If the paper shredder will not start, please check the following:
1.
2.
3.
4.
5.
In case of jammed paper, please follow the procedure below:
1.
2.
3.
4.
This machine does not require lubricant. ACCO Brands accepts no liability for
product performance or safety should any lubricant be used on any part(s)
of this machine.
Register this product online at www.swingline.com
Swingline Style+
™ ™
Cross Cut
4 x 23mm
7 sheets
7 sheets
230mm
378 x 203 x 360mm
120Vac~60Hz
3.0 A
Is the machine plugged in correctly?
Is the switch pushed to the 'ON/AUTO' position?
Is the machine jammed with paper?
Has the motor overheated?
Is the shredder bin fully pushed in?
Check if the bin is too full with paper - the bin should be emptied regu-
larly to avoid paper becoming jammed in the cutters.
Slide the switch to the 'REV' ( ) position to reverse the jammed paper.
If the paper is so jammed that it will not come out in reverse function,
slowly push the switch between 'REV' (
this too quickly as this can damage the shredder.
WARNING – Do not under any circumstances use any metal objects (scis-
sors, letter openers etc.) in an attempt to clear the entry – this model has
mains voltage inside the casing, which could cause serious injury.
) and ON/AUTO. Do not do