Foppapedretti CIAO Manual De Instrucciones página 20

• ENGLISH •
TO INSTALL / USE
HOW TO OPEN THE PUSHCHAIR
(fig.1)
Unhook the locking device (a).
Press button "b", as shown in the figure, and lever "c" at the same time.
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked.
INSTALL FRONT WHEELS
Fitting the front wheels (fig. 2): Insert the end bushing into the slot situated in the center of the
wheel block.
A click will indicate that it is inserted correctly.
Check that both the wheels have been fastened correctly, if they are pulled downwards they should not
be released.
Removing the front wheels (fig.3): Press the steel button "a" front wheel released.
FITTING THE BUMPER BAR
Fitting the bumper bar (fig.4): line the bumper bar up with the slots and press on both sides. A click
indicates that it has been fastened correctly.
Removing the bumper bar (fig. 5): press button "A" on both sides of the bumper bar and at the same
time pull to remove it.
ASSEMBLING THE HOOD
Assembly: Place the hood support on the side of the frame in the attachment position, between the
stroller closing hinge and the screw in the lower part of the frame (fig. 6).
Press to fit the hood support onto the frame. Check it is correctly attached. Repeat on the opposite side.
Insert the front arch of the canopy into the support: you will hear a "click" when it is attached correctly.
Repeat on both sides (fig. 7, 8).
Position the elastic bands around the hood hinge (fig. 9).
Fasten the Velcro flaps to the side and back of the seat (fig. 9).
Disassembly (fig.27): Pull the hood support lever outwards to release the fastener (fig. 10).
Repeat on the opposite side.
Unfasten the Velcro flaps and release the back lateral side of the hood from the fastener on the handle
to remove the hood (fig. 11).
With a flat-tipped tool, pry open and slightly lift up tab "a" on the rear canopy support and, at the same
time, remove the arch (fig. 12). Repeat on both sides.
LOWER BASKET
(fig.13)
The basket is screwed onto the lower part of the frame and attached to the back side with a fabric flap
that slots onto the frame. Unscrew and release the flap to remove the basket.
It is recommended to empty the basket before closing the stroller.
WARNING: the maximum transportable weight inside the basket is 4 kg.
TO DIRECT THE FRONT WHEEL
(fig.14)
To activate the movement: push lever "A" towards the stroller.
To block the movement: push lever "A" away from the stroller.
20