Care And Maintenance - Joovy Spoon B Manual De Instrucciones

Care & Maintenance
Maintenance
All of the fittings, snaps, locks, rivets, and other hardware and plastic parts on the walker should be
inspected periodically to ensure that they are secured properly and not damaged or malfunctioning.
The straps and fabric items and their stitching should also be inspected periodically to ensure that
they are secured properly and not loose, torn or otherwise damaged. All moving parts should also
be checked periodically to ensure they are operating properly.
Any missing, broken, or worn components should be replaced immediately, and the walker should
not be used until they are replaced. Only original manufacturer's components should be used. If
needed, please contact Joovy at our toll-free phone number (877) 456-5049.
Cleaning
The fabric seat cover can be machine washed or cleaned using mild household soap or detergent
and warm water on a sponge or clean cloth. Always allow the fabric to completely dry before
reassembling the seat. DO NOT wash the pad with the clips.
The frame, wheels, and tray should always be kept clean and free of dirt and foreign matter.
Use a sponge or cloth dampened with warm water and a mild detergent cleaner to clean these
components after such use. The friction pads on the underside of the frame should be cleaned
ONLY using a sponge or cloth dampened with warm water. NEVER use abrasive cleaners on these
pads.
(15)
I WARNING:
stopping performance.
Rear Wheels Cleaning
• If it becomes necessary to clean the rear wheels, first turn the product so that it is resting on its
front.
• While holding the wheel and the end of the axle bolt, rotate the axle locking knob counterclockwise
to remove it. (16)
• Push the axle bolt through the wheel, grasp the head of the bolt and pull to remove it. (17)
• Remove the wheel from the wheel cap. (18)
• Use a sponge or cloth dampened with warm water and a mild detergent to clean the wheel and
inside the wheel cap.
• Reinstall the wheel inside the wheel cap making sure to line up the holes in the wheel with the
holes in the wheel cap. (19)
• From the INSIDE of the product, push the axle bolt through the hole in the wheel cap, then through
the wheel, and finally through the other side of the wheel cap. (20)
• Replace the axle locking knob onto the axle bolt and tighten it by rotating it clockwise. (21)
Tighten it securely.
I WARNING:
are small parts. DO NOT allow children to handle or play with
them. Ensure that the axle locking knob is securely tightened
and ALWAYS check to make sure it is tight before each use of the
product.
8
Clean friction pads regularly to maintain
The axle bolt and axle locking knob