Spark Plug Service - MTD 1T65 Shown Manual Del Operador

Paper Filter
1. Remove the air filter cover by turning counter-clockwise
then pulling it towards you. See Figure 6-3.
NOTE: Paper filters cannot be cleaned and must be
replaced once a year or every 100 operating hours; more
often if used in extremely dusty conditions.

Spark Plug Service

WARNING:
plug removed. DO NOT crank engine with spark
plug removed.
To ensure proper engine operation, the spark plug must be
properly gapped and free of deposits.
1. Remove the spark plug boot and use a spark plug wrench
to remove the plug. See Figure 6-4.
Spark Plug Boot
12 S 6 — M
ection aintenance
Figure 6-3
DO NOT check for spark with spark
Spark Plug
Figure 6-4
WARNING:
If the engine has been running, the
muffler will be very hot. Be careful not to touch the
muffler.
2. Visually inspect the spark plug. Discard the spark plug
if there is apparent wear, or if the insulator is cracked or
chipped. Clean the spark plug with a wire brush if it is to be
reused.
3. Measure the plug gap with a feeler gauge. Correct as
necessary by bending side electrode. See Figure 6-5. The
gap should be set to 0.030 in.
Electrode
0.030 in.
Figure 6-5
4. Check that the spark plug washer is in good condition
and thread the spark plug in by hand to prevent cross-
threading.
5. After the spark plug is seated, tighten with a spark plug
wrench to compress the washer.
NOTE: When installing a new spark plug, tighten 1/2 turn
after the spark plug seats to compress the washer. When
reinstalling a used spark plug, tighten 1/8-1/4 turn after the
spark plug seats to compress the washer.
IMPORTANT: The spark plug must be securely tightened.
An improperly tightened spark plug can become very hot
and may damage the engine.