CMT ORANGE TOOLS CMT333 Manual De Instrucciones página 6

INSTALLATION & DRILLING ADJUSTMENT
According to the hinge model, install the relative chuck
head (Fig. 2) on the multipurpose support (Fig. 1) by
means of the two rear locking screws (1).
Position the drilling system on a work surface suited
to the type of machining. Procure a steel bar with a
diameter of Ø10mm (3/8") and a length suited to
the type of machining to be carried out and fit it in
the side hole (2). Adjust the reference stop and lock
everything with the two clamp knobs (3) and fix one
or more reference shims on the table according to the
length of the workpiece to be drilled (Fig. 4).
Set drilling distances (Fig. 3): From the panel's edge
to the hinge (D) by means of the plate and centre
clamp knob (4) and the drilling depth (H) with the
threaded bar and lock nut (5), then position the
workpiece to be drilled (Fig. 4). The bits suited to the
head chosen are then fitted to the three arbors: on
the centre arbor (6) fit and lock the Ø35mm bit for ri-
ght hand hinges, whereas, on the two side arbors (7),
fit left-hand Ø8mm or Ø10mm bits for blind holes.
(according to the type of hinge), which are fixed with
the two dowels, (Fig. 2).
Fig. 3
Use
Use is easy and rapid. Once the equipment is ready, all that has to be done is to fit the shaft of the drilling
system (8) to the arbor of a normal electric or battery-powered column drill and carry out the drilling.
Drilling speed depends on the work piece and the type of bit used.
Maximum rotation speed: 5000 rpm.
N.B.: Before starting the drilling system, check that the tools are correctly tightened and direction of
machine rotation, to ensure that the tool turns in the correct drilling direction.
6
48
3
2
Fig. 1
CMT333
WORK SURFACE
Fig. 4
1
5
4
8
7
Fig. 2
STEEL BAR Ø10mm (3/8")
REFERENCE SHIMS
WORKPIECE
www.cmtorangetools.com www.cmtorangetools.com
6