Association Of Appliance And Rf Control; Cleaning; Important Information On Eco-Compatible Disposal - Vortice NORDIK AIR DESIGN 140-17 Manual De Instrucciones

ENGLISH
Association of appliance and RF remote control
Each appliance is associated at the factory with a remote control.
Should the user wish to associate more than one appliance with the remote control, the following procedure is
required (to be carried out by the installer):
- wire up the appliance completely (connect the PCB to the light and to the motor);
- supply power to the appliance: programming of the remote control must commence within 60 seconds of the
appliance powering up;
- initialization: press the UP-DOWN-UP-DOWN-CENTRAL buttons in sequence. Successful initialization is
indicated by two blinks of the Room light
- select the first channel (Led 1) with the left/right arrows and press the central button: successful programming
of the first channel is indicated by 1 blink of the Room light;
- select the second channel (Led 2) with the left/right arrows and press the central button: successful
programming of the second channel is indicated by 2 blinks of the Room light;
- select the third channel (Led 3) with the left/right arrows and press the central button:
successful programming of the third channel is indicated by 3 blinks of the Room light;
- select the fourth channel (Led 4) with the left/right arrows and press the central button: successful
programming of the fourth channel is indicated by 4 blinks of the Room light;
- select the fifth channel (Led 5) with the left/right arrows and press the central button: successful programming
of the fifth channel is indicated by 5 blinks of the Room light;
- select the sixth channel (Led 6) with the left/right arrows and press the central button: successful programming
of the sixth channel is indicated by 6 blinks of the Room light;
Note:
Receiver Class 2

Cleaning

Fig.: 39 ÷ 41
Before carrying out any type of cleaning or maintenance operation, turn the appliance off at the main switch and,
if equipped with a plug, unplug it from the power supply.

Important information on eco-compatible disposal

IN CERTAIN EUROPEAN UNION COUNTRIES THIS PRODUCT DOES NOT FALL WITHIN THE
REQUIREMENTS OF NATIONAL LAWS IMPLEMENTING THE RAEE DIRECTIVE AND, IN THESE
COUNTRIES, THE PRODUCT IS NOT SUBJECT TO SEPARATE DISPOSAL OPERATIONS AT THE END
OF ITS WORKING LIFE.
This product complies with European Directive 2002/96/EC.
At the end of its useful life, the product marked with the crossed out wheeled bin must be
disposed of separately from urban waste. It must be taken to a differentiated disposal centre
for electrical and electronic appliances or be returned to the retailer when a new equivalent
appliance is bought.
Subject to current legislation on waste disposal, the user is legally responsible for taking the
appliance at the end of its useful life to a suitable disposal centre.
Appropriate differentiated waste collection for subsequent recycling, treatment and
environment-friendly disposal of the discarded equipment helps to prevent possible negative
environmental and health effects and encourages recycling of the component materials of the equipment.
For further information about available waste disposal systems, contact your local waste disposal service or the
shop where you bought the product.
The manufacturers and importers comply with their responsibility for recycling, treating, and environmentally
compatible disposal of waste both directly and collectively.
10