Velleman CTC1000KP Manual Del Usuario página 9

Home Mode
Disarm Mode
Enter Test Mode
Panic Alarm
Fire Alarm
Medical Alarm
11. Test mode
You can use the test mode to avoid tamper alarm when installing,
replacing low batteries or moving the keypad to a different location.
To put the keypad in test mode:
 Enter the PIN code (default: 0000) followed by ＊.
The green LED will flash, a long beep sounds.
 To exit test mode, press
The keypad will sound a long beep and the green LED will remain
lit.
Test mode: key combinations
In test mode, you can use the following key combinations:
Change the PIN code
V. 01 – 12/06/2013
CTC1000KP
Red LED flashes 5 times, a long beep sounds.
Press .
Red LED flashes 5 times, keypad sounds 3
beeps.
Enter a control panel user code and
Red LED flashes 5 times, keypad sounds 2
beeps.
Enter keypad PIN code and press ＊ key.
Green LED lights on, keypad sounds 1 long
beep.
Press 1 + 3 simultaneously.
Red LED flashes 5 times, a long beep sounds.
Press 4 + 6 simultaneously.
Red LED flashes 5 times, a long beep sounds.
Press 7 + 9 simultaneously.
Red LED flashes 5 times, a long beep sounds.
twice.
9
Press ＊ and then 6.
Enter old pin code and press .
Enter new 4-digit pin code and
press #.
.
©Velleman nv