Publicidad
Idiomas disponibles
Idiomas disponibles
ENERGY AVANT
RGB
ENERGY AVANT 4 RGB
100-240ac
AVISO
BEFORE BEGINNING INSTALLATION OF THIS PRODUCT,
PLEASE READ THE INSTRUCTIONS CAREFULLY AND
STORE THEM IN A SAFE PLACE.
INSTALLATION MUST BE CARRIED OUT BY QUALIFIED
PERSONNEL.
IMPROPER HANDLING OF THE COMPONENTS OR OF
THE LUMINAIRE ITSELF MAY DAMAGE THE CORRECT
OPERATION OF THIS PRODUCT AND WILL VOID THE
MANUFACTURER'S WARRANTY.
THE MANUFACTURER'S WARRANTY IS VOID: IF
INSTALLATION IS NOT CARRIED OUT IN ACCORDANCE
WITH THE REBT 2002.
THE APPLICATION OF ITC BT09-4 OF THE REBT
(INSTALLATION OF SURGE PROTECTORS IN LINES AND
LUMINAIRES) FOR INDUSTRIAL AND PUBLIC LIGHTING
INSTALLATIONS IS MANDATORY. THE WARRANTY DOES
NOT COVER DAMAGE CAUSED BY OVERVOLTAGE IN
LUMINAIRES WITHOUT SURGE PROTECTORS.
OBSERVE
THE
HANDLING COMPONENTS SENSITIVE TO
ELECTROSTATIC DISCHARGE (LED).
149
42
217
45
PRECAUTIONS
FOR
BROWN
YELLOW/GREEN
BLUE
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
ENERGY AVANT 6 RGB
PRECAUTIONS:
• This product is for outdoor use.
• Do not handle the product while it is in operation. When handling, switch
off the power supply.
• Do not immerse this product in water or handle it with wet hands.
• If the product is damaged, replace it with a new one.
• In the event of breakage or damage to the protective glass, it must be
replaced immediately.
• Do not touch the body of the protector when it is hot.
• Carefully follow the instructions in this manual.
• If in doubt, consult a qualified technician.
• The flexible cable or outer cord of this luminaire cannot be replaced; if
damaged, the luminaire must be destroyed.
• The connection block is not included. The installation may require the
intervention of a qualified person.
• The luminaire should be positioned so that a long look at the luminaire at a
distance closer to x 1m is not expected.
ASSEMBLY INSTRUCTIONS:
1. Turn off the power.
2. Remove the bracket from the luminaire.
3. Attach the bracket to the mounting surface with the appropriate screws.
4. Attach the luminaire to the bracket with its accessories.
5. Connect the line (L), neutral (N) and ground cables (
the power cord.
6. Adjust the position of the luminaire and tighten the screws.
7. Turn on the power.
CHARACTERISTICS:
• Maximum mounting height <5m.
• Control battery not included.
The luminaire can be connected to the mains via
a connection block, e.g. Stucchi type 1602/VCB-
SM, 2602/VCB-SM. As an alternative, a watertight
connection block can be used, e.g. Techno type
THB384A1A, THB384B1A.
149
42
217
45
) correctly to
Publicidad
