Tabla de contenido
Publicidad
76
English
3.1.19 W
Arning
3.1.20 W
Arning
3.1.21 W
. When directed towards tyres, tyre valves or other pressurised
Arning
components, the high pressure jet is potentially dangerous. Do not use the
rotating nozzle kit, and always keep the jet at a distance of at least 30 cm during
cleaning.
3.1.22 W
. The use of non-original optional attachments that are not manufacturer-
Arning
approved is strictly prohibited. All modifications to the appliance are prohibited;
any modifications shall render the Declaration of Conformity null and void and
relieve the manufacturer of all liability under civil and criminal law.
3.2
SAFETY "MUSTS"
3.2.1 W
. All electrical conductors MUST BE PROTECTED against the water jet.
Arning
3.2.2 W
. The electric supply connection must be made by a qualified electrician
Arning
and comply with IEC 60364-1. Either a residual current device that will cut off
the power supply if the leakage current to earth exceeds 30 mA for 30 ms or a
ground fault interrupt device must be installed.
3.2.3 W
. DURING start-up, the appliance may cause network noise.
Arning
3.2.4 W
. Use of a residual current breaker (RCB) will provide additional
Arning
protection for the operator (30 mA).
3.2.5 W
Arning
3.2.6 W
. Use only approved electrical extension leads with suitable conductor
Arning
cross-section.
3.2.7 W
. Always turn off the switch when leaving the appliance unattended.
Arning
3.2.8
W
. High pressure may cause parts to rebound: wear all the protective
Arning
clothing (PPE) and equipment needed to ensure the operator's safety.
3.2.9 W
. Before doing work on the appliance, REMOVE the plug.
Arning
3.2.10 W
. Before pressing the trigger, GRIP the gun firmly to counteract the recoil.
Arning
3.2.11 W
. COMPLY WITH the local water supply authority regulations. Under IEC
Arning
60335-2-79, the appliance may only be connected to the mains drinking water
supply if the supply hose is fitted with a backflow preventer valve with drain
facility corresponding to EN 12729 type BA. The backflow preventer can be
ordered from the manufacturer.
. DO NOT allow vehicles to drive over the high pressure hose.
. DO NOT move the appliance by pulling on the high pressure hose.
. Models supplied without plug must be installed by qualified staff.
Publicidad
Tabla de contenido
