Electrical Connections - KLASS Fan Modulo Serie Manual De Instrucciones

ELECTRICAL CONNECTIONS

ATTENTION! Make sure the circuit breaker is disconnected.
Take the receiver from the remote control and slide it under the ball joint of the
fan. Be careful not to break the side cables of the receiver. Connect the eclectic
network to the terminal or domino located by the plate. Be careful, do not reverse
the Phase and Neutral cables. Look after the black wire as it is the receiver antenna.
Connect the cables coming out of the fan using
the connector, do the same with the cables of
the exit of the domino.
Make sure the cables at the terminal block are
connected properly.
Work carefully with the cables, without forcing
the connectors, reassemble the canopy.
Rotate the canopy to secure it in its housing,
use the screws to fix the canopy.
L wire (brown)
N wire (blue)
Green wire
Green wire
10
Remote control
receiver