Watercourse And Waterfall; Cleaning & Maintenance - Oase Atlantis Serie Instrucciones De Uso

For subsequent cleaning with the Jet-Clean System (Fig.2):
Screw a normal garden hose with hose adapter onto the Jet-Clean connection.
Note: Only connect the garden hose to a water tap as needed and for the time
required for cleaning. Thus you will prevent pond water from reaching the public
water supply (Drinking Water Protection Ordinance) if there is a pressure drop.
Setting up the pump
You can operate the pump in either a horizontal or vertical position depending on
the depth of your pond. Because of the filter openings positioned high on the unit,
the pump can also be setup on substrates with a lot of debris.
1. Place the pump:
-
-
-
2. Loosen the blue threaded collar and pivot the hose on the pump into the
3. Tighten the blue threaded collar.
Layout the hose to the spring
1. Lay the hose
-
-
2. Adjust the flow-rate regulator to the desired flow-rate quantity.
Connecting
Never operate the pump without the pump filter. The pump filter protects the pump
from coarse debris that can lead to pump blockage.
1. Connect the pump to the power supply. The pump switches on automatically.
2. Unplug the power plug, to turn off the watercourse/waterfall.

6. Watercourse and waterfall

The width of your watercourse is based on the pump output capacity, the flow
rate of the water, the hose diameter; and of course on the streambed that you
have prepared. The pump designation corresponds in this regard to the maximum
stream width, for example Atlantis 60 is suitable for a stream width of 60 cm.
By turning the regulator on the flow-rate valve you influence the water quantity
that is displaced.
With the OASE FM-Master 3 you can regulate the capacity of your pump elec-
tronically via remote control. Attention! Do not use off-the-shelf dimmers, as this
can overheat and destroy the pump.
7. Cleaning/maintenance
-
-
Jet-Clean System (Fig. 2 2 2 2 2 )
Use the Jet-Clean System to clean the pump filter from adhering debris such as
leaves or algae.
First connection:
1. Unplug power plug.
2. Screw a normal garden hose with hose adapter onto the Jet-Clean connection.
Cleaning:
3. Connect garden hose to the water cock or garden pump.
4. Turn on the water. Debris deposits on the pump filter will be washed away.
5. After cleaning: Turn off the water, disconnect the garden hose from the
12
Atlantis 30 Exp..p65
GB Operating instructions
completely under water,
maximum 4.0 m under the surface of the water
on a firm substrate (a stone slab, for instance)
desired direction.
always at an incline. This prevents the formation of air bubbles in the hose.
in a protected manner so that damage is prevented.
Follow the safety instructions (chapter 4).
Clean as needed, this means if the pump performance decreases.
water cock or garden pump.
12
GB
06.03.2003, 14:20