Advanced Settings - Marmitek Megaview70 Manual De Instrucciones

6. ADVANCED SETTINGS

The MegaView70 comes with default settings for use in the most common situations. If your
situation is different, you can change the settings mentioned below.
With the Mode key you can change the following settings:
• CH (channels)
• Po (output signal strength)
• Pb (country code)
Mode
CH 04 ~ 69
Po PH
PL
Pb Eu
It
nE
Au
A
U
By keeping the
the following settings:
Press the Mode key to leave the menu and your settings will be stored.
Units ( ) Value ( )
0 0
1 (default)
1 0
1 (default)
2
3
2 0 (default)
1
3 0 (default)
1
4 0 (default)
1
5 0 (default)
1
8
Description
Setting the channel
output signal of +/- 95dBuV
output signal of +/- 85dBuV
Europe, CH in VHF2 is 5 ~ 12, CH in UHF is 21 ~ 69
Italy, CH in VHF2 is 4 ~ 10, CH in UHF is 21 ~ 69
New Zealand, CH in VHF2 is 4 ~ 10, CH in UHF is 21 ~ 69
Australia, CH in VHF2 is 6 ~ 11, CH in UHF is 21 ~ 69
Morocco, CH in VHF2 is 4 ~ 10, CH in UHF is 21 ~ 69
United Kingdom, CH in VHF2 is 4 ~ 10, CH in UHF is 21 ~ 69
and keys pressed in for a short period of time you can change
Function
0.0 Picture-to-sound carrier ratio is 12 dB
0.1 Picture-to-sound carrier ratio is 16 dB
1.0 Sound subcarrier frequency 4.5MHz
1.1 Sound subcarrier frequency 5.5MHz
1.2 Sound subcarrier frequency 6.0MHz
1.3 Sound subcarrier frequency 6.5MHz
2.0 UHF oscillator on
2.1 UHF oscillator off
3.0 Sound oscillator on
3.1 Sound oscillator disabled
4.0 Test pattern signal off
4.1 Test pattern signal on
5.0 Sound auxiliary output on
5.1 Sound auxilliary output off
© MARMITEK