IBO AJ50/60 Manual De Instrucciones página 14

substances containing sand or abrasive elements may lead to faster pump wear or damage to
the device. In this case, the repair can not take place under warranty.
CAUTION The use of deifferent then well filters may reduce the flow of the installation
as a consequence of breaking the water column, dry running and damage to the pump. In this
situation, the repair can only take place in paid mode.
3. INSTALLATION OF PUMPS AND HYDROPHORIES
CAUTION It should be remembered that all connections coming out of the device
and entering the device are tight because any leakage on the installation: pipes and
connections will lead to the air pump sucking in through the pump. In this case, the pump will
not get the declared parameters or it will work without water, which may lead to its
destruction. In addition, leaks may cause engine flooding and malfunction.
CAUTION The device must be installed in a closed ventilated room, on levelled
horizontal plane. The room must be selected in such a manner, so that the device is not
exposed to high levels of humidity or frost where the temperature does not drop below 0
The pump should be placed on a flat and level surface. The use of a pump or a hydrophore in
the conditions described above (frost, rain, snow) will damage the pump or pressure switch
and its repair will only be possible in paid the mode.
CAUTION 230V / 50Hz power supply must be connected to the pump with earthing. In the
case of drilled wells, it is necessary to install a non-return valve directly above the well filter.
In the case of vertebral wells it is necessary to use a hose ending with a suction basket with a
non-return valve. The basket should not be mounted lower than 30cm above the bottom of the
well and should be mounted at least 30cm below the lowest water level to which the mirror
falls. The basket can not be mounted at such a height, at which there is a risk of it coming out
of the water, which will cause the pump to run dry and damage it. Repair resulting from this
type of event will be possible only in paid mode.
CAUTION The suction pipe must have a drop in the direction of the shot so that there is no
siphon at any point preventing complete and accurate filling of the system with water.
CAUTION Before starting the pump or the hydrophore, the pump should be
primed and the suction pipe should be primed with water. Water can be filled through the
priming hole after removing the priming screw on the suction body or over the discharge port.
After priming the pump, screw off the filling screw and then connect the pump with the
pressure system. Not filled with the pump or the hydrophore and the pipeline before
commissioning will lead to the seizure of hydraulic components and may lead to the
destruction of the pmpy engine. In both cases, the repair can only take place in paid mode.
CAUTION to connect the pump to the suction installation, do not use anti-vibration hoses
because of the possibility of jamming the inside of the hose and blocking the water flow,
which can cause dry running and destruction of the pump or the hydrophore.
CAUTION All connections should be sealed with Teflon. Do not use when tightening the
pipes with a high force due to the possibility of damage to the spigots and suction connectors.
o
C.
14