AGV K-3 SV Manual De Instrucciones página 19

5) ACCESSORIES
1
1
3
An inner sun visor is available for the K-3 SV. This
visor can be operated from the outside, retracts when
not in use and can be easily removed for cleaning or
replacement without need of any special tools.
5.1) Operating the sun visor
To raise or lower the sun visor, simply use the lever
on the left side of the helmet near the main visor
2
mechanism.
To lower the sun visor, push the lever up (1). To retract
the sun visor, push the lever down (2).
5.2) Removing/fitting the sun visor
The non-scratch polycarbonate sun visor is fitted with
catches which mesh with internal teeth alongside the
cheek pads.
We recommend that you carry out the following
tasks with the helmet resting on a level surface.
2
To remove the sun visor, lower it fully then raise
the visor to the fully open position (1). Start on one side
of the helmet by pressing the sun visor gently inwards
then release the catch (2). Repeat on the other side
and remove the sun visor.
NB: When you have removed one side, do not pull
or force the sun visor in any direction other than
the horizontal plane of the guide to remove the
4 other side.
To fit the sun visor, place the operation lever in the
lower position and make sure that the lateral guides
are in the lowered position.
N.B. The left guide is operated with the lever on
the outside of the helmet. The right guide can be
lowered manually (3).
Start on one side of the helmet with the visor fully
open, insert the sun visor catch into place in the lateral
position and make sure that it is sitting on the lateral
guides (4). Repeat on the other side of the helmet.
Make sure that the sun visor is working properly.
19