Starting Work - Comet YA Serie Manual De Instrucciones

WARNING
• Follow the start-up procedure recommended by the Manufacturer of the machine with the pump.
• Read the information and warnings on the label of any chemicals to be distributed with the pump with due
care to prevent potential danger to people and the environment.
• Keep chemicals in a safe place and out of children's reach.
• In case of contact with the eyes, wash immediately with water and contact a doctor immediately: remember
to take the container of chemical with you .
• In case of swallowing, do not provoke vomiting and contact a doctor immediately: remember to take the
container of chemical with you .
• Never operate the pump at pressures above the maximum operating pressure (refer to section on
AND SPECIFICATIONS")
For what follows, refer also to the documentation accompanying the control unit:
a) Set the delivery pressure to zero by operating on the control unit, so that you can set it to "by-pass".
b) Start the pump to prime it.
c) Operate on the control unit, so that you can set it to "pressure".
d) Rotate the pressure adjusting knob of the control unit in the suitable way, until you reach the wished
pressure value.
CAUTION
• For rapid pump priming, carry out step a) each time the pump is drained.
• During the first hours of pump operation, check the oil and top up, if necessary, as instructed in the section
on
"PRELIMINARY CHECKS"
WARNING
• Follow the instructions for stopping work provided by the Manufacturer of the machine with the pump.
THERE MUST BE NO MOVING PUMP PARTS AND NO PRESSURISED LIQUID IN THE HOSES.
a) Turn off the delivery pressure as described in point a) in the section on
b) Stop the pump.
WARNING
• Follow the storage instructions provided by the Manufacturer of the machine with the pump.
CAUTION
• Read the instructions for storage in the operating and maintenance manual for the machine with the pump.
After using it for the last time, clean out the pump by taking up clean water. Never store the pump with
pumped fluid inside it.
•
THE PUMP IS SENSITIVE TO FROST.
In cold environments, protect the pump by preventing the formation of ice inside the pump by taking up antifreeze
(diluted appropriately for the envisaged temperature). Drain it completely by running it dry for several minutes.
WARNING
• Dispose of antifreeze properly.
22

STARTING WORK

.
.
STOPPING WORK
STORAGE
"FEATURES
.
"STARTING WORK"