Beper RI.415 Manual De Instrucciones página 13

Electric Overblanket Use instructions
PRODUCT DESCRIPTION (Fig. 1)
1. Heating surface.
2. Label
3. KDA-6FT control
4. On/off button
5. Display
6. Temperature set key
7. Time set key
8. Cancel Key
9. Powet cord
10. Cable for connetion to blanket socket
11. Powet plug
HOW TO USE THE ELECTRIC OVERBLANKET
Beper plaid is designed for use as a heating blanket placed over the bed or as a shawl for
personal use in any location.
It may not be placed between the mattress and bedsheet.
The control must be within the user's reach, on top of the blanket itself, for ease of use
without impeding the user's movements, and never underneath the user.
1. Unfold the blanket completely: when folded on itself, as this may damage the fabrics.
2. Make sure the power socket is close enough to the position in which the blanket is to be
used to enable the control to be hooked up and used conveniently, and without the power
cord being a hazard (risk of persons tripping over it).
3. Connect the control to the blanket through the appropriate contact.
4. Connect the power cord to the socket (230V/50Hz).
5. Make sure that the cord is not twisted.
6. Do not use any control other than that supplied (KDA6-FT).
7. Switch the blanket on by setting the control's side switch to ON: the power led will light
up.
8. Now, set the temperature with the Temperature key (Temperature set): during initial
warming it is best to press the key repeatedly until all 5 leds are lit up, indicating maximum
temperature. It takes the blanket around 30 minutes to reach its maximum temperature.
9. When the blanket reaches the desired temperature, adjust the temperature with the
temperature key by pressing it repeatedly to light up a different number of leds.
13