Cleaning And Maintenance; Technical Support - ROSIERES FE9163 Instrucciones De Uso

Cleaning and maintenance

Important: before carrying out maintenance on the oven, it must always be unplugged from
the power supply or disconnected from the mains via the electrical system master switch.
The stainless steel and enamelled parts will keep their finish if cleaned with water or using
specific products, drying them thoroughly.
Avoid using products that contain chlorine or diluted chlorine solutions, caustic soda, abra-
sive detergents, hydrochloric acid, vinegar and other products that can scratch.
Stains left on the bottom of the oven (sauces, sugary substances, egg white and fats) are
caused by spatters or spillages of food. Spattering occurs during roasting and is due to the
temperature being too high whereas spilling is due to containers being too small or to food
increasing in volume during cooking.
These two problems can be solved by using high-sided containers or by using the dripping
pan supplied with the oven. When cleaning the lower part of the oven, you are advised to
remove any stains while the oven is still warm - the longer you wait, the more difficult it will
be to remove them.
Immediately after use while the oven is still warm but switched off, you are also advised to
place a cloth soaked in ammonia - a few drops are sufficient - on the bottom of the oven.
Close the oven door, wait approximately 10 minutes and then dry thoroughly.

Technical support

If the oven does not work correctly, you are advised to check the following before calling the
technical support service:
CHECK THAT THE PLUG IS CORRECTLY INSERTED IN THE SOCKET
CHECK THE PROGRAMMING OF THE ELECTRONIC PROGRAMMER
If the cause of the fault is identified, switch the appliance off, do not tamper with it and call
the Technical Support Service, specifying the model indicated on the identification plate at
the bottom of the front of the oven.
The appliance is provided with a guarantee certificate which entitles the user to free use of
the TECHNICAL SUPPORT SERVICE for one year from the date of purchase, the only
expense being a fixed call-out fee. The guarantee certificate must be filled in and kept so that
it can be shown to the TECHNICAL SUPPORT SERVICE.
11