Dear Client,
Congratulations for choosing one of our quality products. Please follow these instructions carefully and keep them with you.
Functionality
The Marten-Free-Device generates an acoustic signal with a frequency of 12 kHz in intervals of each 15 seconds turn-on and turn-off time. This
ultra high frequency is sensed by the martens as perturbing and nasty, so that they flee from the corresponding vehicle.
Assembly
The Marten-Free-Device is fastened by means of self-tapping screws or binders in the engine compartment on the carriage. The connecting cable
to the car battery must be passed in that manner that it doesn't get in contact with movable or hot parts (e.g. ventilating wheel, exhaust manifold).
The device should be placed in the engine compartment in that manner that the acoustic noise can constantly spread and is not absorbed by
insulating mats.
ATTENTION: self-tapping screws / binders not included
ATTENTION: The assembly should be carried out by authorised specialised staff!
Electrical connection
The device is directly connected to the car battery. The black cable is connected to the positive pole, the brown one to the negative pole. If
additionally the grey cable is connected to clamp 15 (ignition lock, car radio) of the car battery, the control automatically switches on the device,
when the ignition is turned off and automatically switches it off, when the ignition is switched on. This increases the durab ility of the device, as it is
only put into operation with the motor turned off.
NOTICE: If you do not intend to use your car for some time, please disconnect your Marten Free to preserve the battery
General information
1.
Electric appliances, packaging material etc. should be kept away from children.
2.
Dispose packaging and worn out material correctly and in an environmentally friendly way.
3.
Do only pass on the device including the operation manual.
4. Subject to change of design and technical data without notice for the sake of constant product improvement.
General notes
When your car has already been visited by martens, most likely the animals left their marks for the identification of their area. These odours must
unconditionally be removed before the assembly of the Marten-Free-Device, as other martens could possibly enter even to a bite protected
engine compartment. The best way to do so is by means of an efficient motor wash. Furthermore, the animals leave their marks frequently under
the vehicle, e.g. on the car park. It is therefore recommendable to remove these traces with detergents and mop in order not to give any reasons
to the marten to be forced to defend its area.
Technical data
Operating voltage:
Charging rate:
Frequency:
Power consumption:
Micro-Fuse:
Acoustic pressure:
Connecting line:
Angle of reflected beam:
Safety instructions
Important: Damage caused by not adhering to the operating instructions is not covered by guarantee. Gardigo accepts no liability whatsoever for
any resulting consequent damages.
-
Only operate the device at its intended voltage.
-
In case of repairs, only use original spare parts, to avoid serious damage.
-
Check feed cables and conducting cables connected to the device for breaks or insulation defects. If you find a defect, or there is visible
damage do not use the device.
-
Repairs or other works, e.g. changing a fuse, etc. may only be carried out by an appropriately trained, skilled person.
-
It must be noted that operator or connecting errors lie outside the influence of Gardigo and we cannot accept any liability for resulting
damages.
-
Always check whether the device is suitable for the respective place where you intend using it.
Guarantee
We grant a two year guarantee for this device. Guarantee includes repair of all defects that were not caused by defective material or fabrication
mistakes. Guarantee does not apply on wearing parts. Since Gardigo has no influence on correct and appropriate assemblage and operation it is
obvious that guarantee applies only on completeness and proper condition. AutoStyling Seehase takes on neither liability nor guarantee for
damages or consequential damages in connection with this product. This applies especially when the device was altered or repa ired, when
circuits were changed or non-original spare parts were used or when damage was caused by false or negligent operation or abuse.
Your
Gardigo-Team
Instructions for Use
Marten-Free
Article No.78405
12 V DC
approx. 7 mA
12 kHz
appr. 0,1 W
0,2 A
appr. 85 dB
appr. 30 cm
appr. 160°
Ohestraße 13D, 38159 Vechelde, www.gardigo.de, Tel: (07 00) 93 72 32 27
e11
035173
Status: 01/12