Fuel Filling; Flame Ignition - Planika Prime Fire 990 + Manual De Usuario

1. If the tank is empty (
hose 'a' (click!) and power cable 'b' (II) (
2. Place the fuel container stably on the floor and insert the pump hose 'c' (III). Press and hold the button
on the pump to start refuelling (IV).
Once the fuel container has been emptied, replace it with a full one and start the pump again (see point 2).
The pump will stop when the tank is full (sound +
3. Disconnect the power cable 'b'. To disconnect the pump, hold the end of the hose 'a' and firmly press the button in
the place marked with a sticker (V). Close the fuel inlet..
4. Shake the remaining fuel from the hose 'c' to the container and place the pump in the bag (VI).
The green diode indicates that the device is ready to ignite the flame.
READY
Press and hold START for 3 seconds. Flame ignition will take 2-10 minutes (
can be present during the ignition. The diode READY off (
and the device reached the working temperature.

FUEL FILLING

) or you want to fill the fuel, open the fuel inlet (I), firmly connect the pump
). ATTENTION!
FUEL
b
a
V

FLAME IGNITION

Do not refuel when the flame is ignited!
).
VI
READY
) indicates that
the flame has been ignited
READY
15
c
). The smell of ethanol vapours