Charging The Battery; Installing And Removing The Battery - Core Troy-Bilt TB4400 Manual Del Operador

CHARGING THE BATTERY

NOTE: The battery is not shipped fully charged.
NOTE: Lithium-ion batteries will not develop a memory and may be
charged at any time.
For maximum run time, fully charge the battery before each use.
1. Plug the battery charger into an appropriate power outlet.
2. Insert the battery into the charging dock (Fig. 2). The LED should
illuminate (Fig. 3). If it does not:
• Make sure the battery is fully inserted into the charging dock.
• Make sure the battery charger is fully plugged into an
appropriate power outlet.
• Make sure the power outlet is functioning by testing it with
another electrical device.
3. Examine the LED. The LED will indicate the battery status:
• Green (blinking): The battery is charging. Charge the battery
until the green light stops blinking.
• Green (constant): The battery is fully charged.
• Red (blinking): The battery and/or charger are too hot or too
cold. Make sure the battery and charger are in an environment
between 32° and 104° F (0° and 40° C). Allow time for the
battery and/or charger to warm up or cool down.
• Red (constant): The battery is no longer functional. Refer to
the Warranty section for replacement information.
4. Once the battery is fully charged, remove it from the battery
charger. Optionally, the battery can be stored in the battery
charger, but the battery charger should be unplugged from the
power outlet.

INSTALLING AND REMOVING THE BATTERY

WARNING:
Avoid accidentally starting the unit. To
prevent serious injury, DO NOT press the throttle lockout
or squeeze the throttle control when installing or removing
the battery. Refer to Starting and Stopping. Remove the
battery from the unit when it is not in use.
Installing the Battery
1. Grasp the rear handle firmly. DO NOT press the throttle lockout
or squeeze the throttle control. Refer to Starting and Stopping.
2. Slide the battery into the battery port (Fig. 4). Push the battery
firmly until the battery locks into place (Fig. 4). There should be
an audible "click" and the battery latch should be in the upright
position (Fig. 4).
Removing the Battery
1. Grasp the rear handle firmly. DO NOT press the throttle lockout
or squeeze the throttle control. Refer to Starting and Stopping.
2. Press the battery latch down to unlock the battery (Fig. 4).
3. Pull the battery out of the battery port (Fig. 4).
LED
Rear Handle
10
Charging Dock
Battery
Fig. 2
Fig. 3
Battery Latch
Battery Port
Battery
Fig. 4