Preparation Before Use; How To Install The Hepa Type Filter - Toyotomi ETK-20E Manual De Instrucciones

PREPARATION BEFORE USE

1

HOW TO INSTALL THE HEPA TYPE FILTER

1
1 Pull the front panel toward you and remove it while pressing the
right and left hooks at the bottom of the main unit.
2
2 Remove the HEPA Type filter in the bag from the main unit.
3
3 Take the HEPA Type filter out of the bag and install the filter with
the white side to the upside.
4
4 Align the nails of the upper front panel with the main unit and
push the right and left areas at the bottom.
★ It is necessary to lay the main unit down to fit the front panel
onto the unit properly.
★If the HEPA Type filter is mounted incorrectly, the filter will not work properly.
★The HEPA Type filter should be replaced about two years after opening the package. The
replacement frequency depends on how long they are used or where they are installed.
¡The lifetime of the filter will become very short in cases where they absorb oily smoke or
carbonized substances such as soot.
★Dirty HEPA Type filter cannot be reused even if they are washed. Be sure to replace them.
( Be sure to assemble the HEPA Type filter before using the Air Purifier. )
NOTE
5