Part Names And Functions - Audio-Technica ATND8734 Manual De Usuario

Thank you for purchasing this Audio-Technica product.
Before using the product, read through this user manual to ensure
that you will use the product correctly. Please keep this manual for
future reference.
• Connects directly to network via Ethernet cable – no
need for expensive audio cable or soldering
• TB3M-type in for quick mounting of hanging
microphone
• Red/green LED indicator
• Settings for mic gain, low-cut filter and LED ring are
adjusted remotely
FCC Notice
Caution
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to
operate this equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
JA
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
EN
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For customers in Canada
IC statement
CAN ICES-3 (B)/NMB-3(B)
• When using the product with connected devices or PCs, be sure to read
the user manuals of the connected devices or PCs as well.
• This product requires Dante-compatible audio equipment (sold separately).
• Before connecting this product, set the sound volume of the device to
KO
which it will be connected to the lowest level.
• When connecting a LAN cable, be sure to do the following:
•Connect to a LAN port that supports a PoE power supply.
CN
•Use a LAN cable that is CAT5e or higher (STP cable is recommended).
•Use a cable that is no longer than 100 m.
•Do not use devices such as distributors in the LAN connection.
TW
• This product is not intended to be connected directly to public internet.
Notes on Use

Part Names and Functions

①
②
④
Product with cover removed
Cover
Protruding bumps
1 Unbalanced input jack
TB3M-type input allows for quick connection of a compatible
Audio-Technica hanging microphone.
2 LED ring
The red and green LEDs can be lit using their respective ON/
OFF controls.
3 Ethernet connector
Supports 100Base-TX. Use CAT5e cable or higher (STP cable is
recommended). This product operates on a PoE power supply.
Connect to a switching hub that supports PoE.
4 External control input
Can be used as a contact
closure for external
control by closing and
opening the circuit
through commercially-
available switches.
Commercially available
switch
5 Cover
6 Connection LED
Lights up green when a link between devices is established.
Blinking indicates that data is being transferred between the
devices.
7 Serial No., MAC Address
1
③
⑤
⑥
⑦
External control input