Steiner Optik Beretta Instrucciones De Uso página 10

Attaching the belt attachment:
1 1 1 1 1 1 1 1 1
With ClicLoc System:
To loosen the carrying strap and unlatch the lock, press and hold the release button
fit can now be pulled off and/or inserted. Make sure that the catch is always facing outwards
and that it audibly engages while being inserted.
2 2 2 2 2 2 2 2 2
Without ClicLoc system:
Please loosen one end of the strap from the side loop and feed the strap from the top through
the eyelet.
3 3 3 3 3 3 3 3 3
strap to tighten it. Repeat these steps to fasten the other end of the strap in the same way.
Attaching the neoprene protection cover and the rain protection cover:
Several rain protection systems may be enclosed with your binoculars that are attached to the
4 4 4 4 4 4 4 4 4
carrying strap. For neoprene protection covers, please ensure that the semicircular opening
on the cover is placed over the focussing wheel
retainer may be threaded laterally through the open eyelet
5 5 5 5 5 5 5 5 5
Attaching the objective protection covers:
If your binoculars are equipped with locking ClicLoc objective protection covers, press on the
visible depression to release the cover and pull it out of its retainer
the snap-on fastener back into the retainer until it is secure and audibly engages. Objective
protection covers that are attached to the centre axis are removed by pulling them over the
6 6 6 6 6 6 6 6 6
centre axis
10
2 2 2 Now pull the carrying strap through the slide loop again and pull firmly on the
.
6 6 6
3 3 3 . For rain protection covers, the strap
4 4 4 provided for this purpose.
5 5 5 . To re-connect it, push
. The snap
1 1 1