Important Safeguards; How To Assemble; How To Operate - Alpina SF-5003 Instrucciones De Uso

Dear Customer,
Thank you for choosing Alpina home appliance. You have chosen the best appliances that offer
2 years/24months warranty and years of service.
friendship forever. We hope you will choose Alpina again and make ALPINA your first choice in
home appliances.
When using electrical appliances, basic safety precautions should always be
followed, including the following:
1. Read all instructions carefully.
2. This appliance may only be connected to the same main voltage as shown on the rating
plate.
3. To protect against risk of electrical shock, do not immerse or rinse housing, cord or plug in
water or other liquid.
4. Close supervision is necessary when any appliance is used near children.
5. Unplug from outlet when not in use, before putting on or taking off parts and before
cleaning.
6. Do not contact any moving parts while the appliance is operating.
7. If the supply cord is damaged, it must be replaced by the manufacturer or its authorized
service agent or a similarly qualified person in order to avoid hazard & damage to the unit.
8. The use of attachment or accessories which are not supplied with the appliance are not
recommended. This could result in electrical shock or injury or permanent damage to the
appliance.
9. Do not let cord hang over edge of table or counter or touch hot surface.
10. Do not use the appliance for other than intended household use.
11. Switch off the appliance before changing accessories or approaching parts, which move in
use.
12. The appliance is not intended for use by young children or infirm persons without
supervision. Young children should be supervised to ensure that they do not play with the
appliance.
13. Do not obstruct the air flow.
14. Do not operate the fan without the guard.
This appliance is for household use and may be plugged into any AC electrical outlet (ordinary
household current). Do not use any other electrical outlet.

HOW TO ASSEMBLE:

1. To assemble safety grille and blade assembly, remove spinner by turning clockwise, then
the locking nut (anticlockwise) from the motor spindle.
2. Place rear of safety grille in position. Ensure grille fits onto locating lugs, the grille's carry
handle will be at the top.
3. Fix grille into position by replacing locking nut tightly by hand. Do not force.
4. The hole in the centre of the fan blade has a flat surface on one side. This will align with a
flat surface on the motor spindle and ensure correct tightening spinner by hand
anticlockwise onto end of motor spindle. The spinner is self tightening, do not force at all.
5. Lift out all locking clips on front safety grille. Place grille into position and secure by
fastening clips over outer rim.
6. Assemble the base to the support pole using the fasteners provided.

HOW TO OPERATE

1. Remove the cable tie and unravel the cord set before operation.
2. Speed controls: 0. Off
3. To blow air in one direction and stop oscillation, allow fan to move into desired position
and pull clutch knob up. Press down to return to normal oscillation function
4. Air flow can be adjusted upward and downward by tilting the fan to the desired position.
We stand for quality, dependability and

IMPORTANT SAFEGUARDS

1. Low 2. Medium
- 3 -
ENGLISH
3. High