Channel Number Setting; How To Check And Deal With Interference; Order Of Actions (Action Flowchart) - Toa WT-5810 Instrucciones De Operación

7. CHANNEL NUMBER SETTING

Step 1. Press the Set key for about a second until the displayed channel number blinks.
Step 2. Select the desired channel number with the NEXT key, and press the Set key for about a second until
the blinking number turns to steady light.
Tip
Continuous or each depression of the NEXT key permits the display to cycle through the channel numbers.

8. HOW TO CHECK AND DEAL WITH INTERFERENCE

8.1. Order of Actions (Action Flowchart)

Pressing RF check key, check signal
condition of the channel.
Change to idle channel.
Pressing RF check key, check signal
condition of the channel.
Adjust squelch to limit transmission distance.
Contact shop from where unit was
purchased.
6
Channel number display
[No]
Any
interference?
[Yes]
[No]
Any
interference?
[Yes]
[No]
Any
interference?
[Yes]
1 2
Refer to p. 7 "8.2. Checking Ambient Signal
Condition."
Use as is.
Refer to p. 6 "7. CHANNEL NUMBER SETTING."
Use as is.
Refer to p. 7 "8.3. Reducing Radio Interference
by the Squelch Control."
Use as is.