Connecting To A Device And Adjusting Volume - ToughTested TT-HF-JOB Manual Del Usuario

CONNECTING TO A DEVICE AND ADJUSTING VOLUME

12
CONNECTING TO A DEVICE AND ADJUSTING VOLUME
The Jobsite earbuds work with all phones and music devices that have a 3.5-mm audio jack.
To connect the earbuds to your phone or music device and adjust the volume appropriately, follow these steps:
1.Set the volume level of your phone or music device to its lowest audible level.
2.Plug your earbuds into your phone or music device.
3.Activate the music on your device or have the person on the other end of the phone begin talking continuously.
4.Press the Volume Up
volume suitable for everyday use.*
Warning: Protect your ears by practicing sensible listening. Extended exposure to high-decibel sounds may cause
permanent hearing loss.
USING EQ-VOICE™
Your control module is equipped with EQ-VOICE™ technology.
Music mode:
Switch EQ-VOICE™ to music mode to listen to enhanced music at a safe volume.
In music mode, the built in equalizer is preset to optimize music quality and the volume is limited to 95 DB.
Call mode:
Switch EQ-VOICE™ to calls mode to have clearer, louder phone calls in noisy environments.
In calls mode the built in equalizer is preset to optimize voice quality and the volume is boosted by 10 DB.
* Control buttons are optimized for IOS devices. All functions may not operate on some devices.
Visit www.tough-tested.com for phone compatibility.
and Volume Down buttons on the control module as needed to reach a safe listening