Water Inlet - Electrolux EWC 1350 Manual De Instrucciones

20 electrolux
POSITIONING
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or furniture. Level the wash-
ing machine by raising or lowering the two
front feet. If necessary, check the setting
with a spirit level. Any necessary adjustment
can be made with a spanner. Accurate lev-
elling prevents vibration, noise and dis-
placement of the machine during operation.
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor.

WATER INLET

Warning! This appliance must be
connected to a cold water supply.
1. Connect the water inlet hose supplied
with the machine to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.
If necessary, use the suitable or sup-
plied restrictor (1/2").
Important! Do not use the hose from
your previous machine to connect to
the water supply.
2. The machine end of the inlet hose can
be turned in any direction. Set the hose
correctly by loosening the ring nut. Af-
ter positioning the inlet hose, be sure to
tighten the ring nut again to prevent
leaks.