Wagan Tech 2450 Manual De Usuario página 5

Ocultar thumbs Ver también para 2450:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cordless Spotlight Compressor
Using as a DC 12 V Power Source
The compressor's 12 V DC Power Socket mimics the 12 V socket of a
vehicle.
Any accessory you would normally plug into your vehicle's 12 V socket
(cell phone, digital camera, flashlight, radio, etc.) can be powered
from the compressor's 12 V socket, using the compressor's built-in
battery as the power source.
This unit's 12 V DC socket is center pin positive (+). Most 12 V DC
accessories come with this configuration, but not all. Before connecting
any accessory to the compressor's 12 V socket, check the accessory
owner's manual for the polarity of the accessory.
If the accessory is center pin positive, simply plug it into the 12 V
socket.
For the DC accessories that are NOT center pin positive, you must use
a DC to DC adapter (not included).
Using the Spotlight or the LED reading light
A. Spotlight: locate the on/off switch on the handle of the unit. Change it
from "O" to "I" position.
B. LED Reading light: locate the on/off switch on the handle of the unit.
Change it from "O" to "II" position.
Note: The halogen and LED bulbs are not designed to be removed by
users. DO NOT attempt to change or modify them.
www.wagan.com
7
by Wagan Tech
®
User's Manual—Read before using this equipment
RECHARGING THE UNIT
Recharging from a 12 V DC Source
(Car, Truck, Boar, 12 V DC Charger)
Important: Do not leave this unit plugged into the 12 V socket when the
vehicle is not running as it may drain power from the car battery. When
charging in a vehicle, leave the engine running or charge while driving.
1. Connect the DC adaptor in the unit's charging socket.
2. Connect the other end of the adaptor in the vehicle's 12 V socket
(cigarette lighter) and let it charge for about 8 to 10 hours.
Recharging from an AC Power Source
1. Connect the AC adaptor in the unit's charging socket.
2. Connect the other end of the adaptor to any household wall outlet. Let
the unit charge for about 25 to 27 hours.
Note: The Wagan Cordless Spotlight Compressor should be charged at least
once every 4 months regardless of usage to maintain charge. Draining a
lead acid battery completely will damage the battery. This is not covered by
the warranty if this occurs. Led acid batteries do not have memory, so the
unit can be charged periodically.
©2013 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido