Pentair EASYCONTROLLER Instrucciones De Uso página 19

METAL CONTAINER APPLICATION CONFIGURATION CHANGE
S3 Work mode configuration
switch
Adjustment Trim
Timing 0-180''
Communications and advanced
functions
WORK MODE CONFIGURATION (S3):
S3
PIN 1
Pin 1 determines the work mode (0: water supply, 1: water disposal).
Pin 2 cyclicality (0: cycle active – 1: cycle not active).
Pin 3 determines the mode (0: second pump electric pump assist, 1: second electric pump standby).
Pin 4 determines the advanced control mode (communication/service).
In standard configuration, the control board is set in water disposal mode. By modifying the positions of the S3 selector contacts,
positioned in the rear part of the board, it is possible to modify the work mode.
S3
PIN 1 2
2 3 4
POS
1
0
3 4
POS
1
0
Water disposal S3=1000
1 duty - 1 assist cyclic
in 2 pumps mode
BMS contacts (with fuse)
BMS (Building Management
System) contacts, see chapter 7
Connector for electric pumps
commands, pressure switches
control and absorptions
F1 contactors command fuse
F2 board power supply fuse
EN
17