Maintenance - IKRA PCS 2525 Instrucciones De Servicio

Freeing a trapped saw
It the saw becomes trapped during cutting, operators
should
- switch off the saw and attach it securely to the tree
inboard (i.e. towards the trunk side) of the cut or to a
separate tool line,
- pull the saw from the kerf whilst lifting the branch as
necessary,
- if necessary, use a handsaw or second chain saw to
release the trapped saw by cutting a minimum of 30
cm away from the trapped saw.
Whether a handsaw or a chain-saw is used to free a
trapped saw, the release cuts should always be outboard
(toward the tips of the branch), in order to prevent the
saw being taken with the section and further complicat-
ing the situation. Freeing a trapped saw.

9. Maintenance

WARNING
Make sure the engine is stopped.
Daily check points
1. Air filter
Loosen the knob and remove the air cleaner cover. Take
off the filter elements and tap off attached sawdust.
When they are extremely dirty, shake wash with gasoli-
ne. Dry them completely before reinstalling.
2. Oiling port
Dismount the guide bar and check the oiling port for
clogging.
GB | Operating Instructions
3. Guide bar
Remove sawdust in the bar groove and the oiling port.
(Type: Sprocket nose)
Grease the nose sprocket from the feeding port on the
tip of the bar.
4. Others
Check for fuel leakage and loose fastenings and dama-
ge to major parts, especially handle joints and guide bar
mounting. If any defects are found, make sure to have
them repaired before operating again.
This saw is equipped with one of the following low
kickback bar/chain combinations:
Part Number
Bar Size
10inch (25cm)
For replacement, use only above bar and chain
Periodical check points
1. Cylinder fins
(1) Oiling port
13
WARNING
Guide Bar
100SDEA041
1. Remove the starter case.
2. Remove sawdust between the cylinder fins.
(1) Groove
(2) Oiling port
(1) Grease port
(2) Sprocket
Saw Chain
Oregon 91P
(1) Cylinder fin