Fuel Mixing Table; Operation - FLORABEST FBS 43 A1 Manual De Instrucciones

fuel. Pour the correct quantities of petrol and
2-stroke oil into the mixing bottle (see scale prin-
ted on the bottle). Then shake the bottle well.

6.4 Fuel mixing table

Mixing procedure: 40 parts petrol to 1 part oil
Petrol
1 liter
5 liters

7. Operation

Please note that the statutory regulations gover-
ning noise abatement may differ from one loca-
tion to another.
Each time before use, check the following :
•
That there are no leaks in the fuel system.
•
That the equipment is in perfect condition and
that the safety devices and cutting devices are
complete.
•
That all screws are securely fastened.
•
That all moving parts move smoothly.
7.1 Starting the engine when cold
Fill the tank with the oil/petrol mix. See also „Fuel
and oil".
1. Set the equipment down on a hard, level sur-
face.
2. Press the fuel pump (primer) (Fig. 1/Item 7)
10 times.
3. Move the On/Off switch (Fig. 1/Item 9) to
„I".
4. Secure the throttle lever (Fig. 1 / Item 1 1).
To do this, press the throttle lever lock (Fig.
1/Item 12) and then press the throttle lever
(Fig. 1/Item 1 1) and lock the throttle lever by
pressing the lock (Fig. 1/Item 10) at the same
time.
5. Set the choke lever (Fig. 1/Item 5) to " ".
6. Hold the equipment fi rmly and pull out the
starter cable (Fig. 1/Item 4) until you feel it
begin to resist. Then tug sharply on the starter
cable 4 times. The equipment should start.
Important: Never allow the starter line to
snap back. This may result in damage.
Anleitung_3401994_LB5.indb 64 Anleitung_3401994_LB5.indb 64
GB/MT
2-stroke oil
25 ml
125 ml
- 64 -
Important: Since the throttle lever is secu-
red, the cutting tool starts to operate when the
engine is started.
Then release the throttle lever by actuating it once.
Actuating the throttle lever will also release the
choke lever. (The engine returns to its idle state).
7. If the engine does not start up, repeat steps
4-6 above.
Please note: If the engine does not start up
even after several attempts, read the section
„Troubleshooting".
Please note: Always pull out the starter cable
in a straight line. If it is pulled out at an angle,
friction will occur on the eyelet.
As a result of this friction, the starter line will
become frayed and will wear away faster.
Always hold the starter cable when the starter
line retracts.
Never allow the starter line to snap back
when it has been pulled out.
7.2 Starting the engine when warm
(The equipment has been idle for less than 15-20
min.)
1. Set the equipment down on a hard, level sur-
face.
2. Switch the On/Off switch to "I" (Fig. 1 / Item
9).
3. Secure the throttle lever (Fig. 1 / Item 1 1) (in
the same way as described in "Starting the
engine when cold").
4. Hold the equipment fi rmly and pull out the
starter cable until you feel it start to resist. Then
tug sharply on the starter cable. The equip-
ment should start after 1-2 tugs. If the equip-
ment does not start after 6 tugs, repeat steps
1 – 7 of the procedure for starting the engine
from cold.
04.12.12 15:51 04.12.12 15:51