Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Hold the protection skirt (1), fit it into the guiding-
hole (2) on the aluminium bar of the transmission
gearbox, place the footstrap (3), the bolts (4), the
fixing nut (5) and tighten them.
Warning!
Never operate your mower without the
protection skirt.
Using the equipment without the
protection skirt is considered loss of
warranty.
Make sure that the on/off key is in the "off"
position and that the cord is disconnected from
the power supply.
Place the equipment carefully on a flat surface
positioning the blade face-up and the handlebars
face-down.
3
2
Mounting the Protection Skirt
Mounting the Cutting Blade
4
5
6
7
8
1
4
Then put the locking pin (1) in the adjusting hole
on the washer (2) to coincide with the hole on
the blade's support base (3) to lock it into place.
Use the blade's mounting key (4) to loosen the
mounting nut (5), observing that the threading is
on the left. Remove the lock washer (6), the plain
washer (7) and place the blade (8).
To mount follow the reverse order in the same
sequence.
Warning!
Never hold the blade when you have to
tighten or loosen the mounting nut - you
might get badly hurt.
Never use blades with external diameter
over 25.5 cm.
The cutting blade's fitting hole measures 1
inch (2.54 cm).
1
5
2
3
31
Publicidad
Tabla de contenido
