3. TRANSPORTATION, PACKAGING AND STORAGE.
3.1 Inspection after transport
A check for damage and completeness of the device must be carried out upon receipt of the parcel. In the
event of damage caused by transportation, refuse the delivered goods or accept it only with reservations *.
After that, you must file a complaint with a detailed description of the defects found. Perception of damage is
only possible in the case of a claim formulated within a specified time frame, that is, a maximum of 24-48
hours.
* written on the carrier's waybills or electronically.
3.2 packaging
Keep the packaging for your device in case you move or return to a service center. The inner and outer
packaging must be completely removed before using the device. Before disposing of the packaging, comply
with the environmental standards in force in your country.
3.3. Storage
WARNING
The device can be stored in a warehouse, but only in its original sealed packaging.
Storage can be carried out in accordance with the following conditions:
• Storage in a dry and dry place.
• Protected from the sun
• Control in the warehouse for more than 2 months (general condition of the device and all components)
• No shaking of the material
• Storage indoors, not outdoors.
4. EQUIPMENT CHARACTERISTICS
* Subject to change
Model
Temperature
Plate diameter
Electrical data
Dimensions
Weight
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger of electric shock!
• Do not allow the power cord to come in contact with heat sources.
• The cord should not hang over the edge of a table or stand.
• Do not pour water into a working or still hot appliance.
• The device must be connected correctly and comply with the regulations in force.
CCR40EP
140 ° C - 300 ° C
400 mm
2700 W / 230 V
H 124 x Ø 400 mm
24 kg
CCC40EP
140 ° C - 300 ° C
400 mm
2700 W / 230 V
W 430 x D 445 x H 180
mm
22 kg
CCD40EP
140 ° C - 300 ° C
400 mm
2700 W / 230 V
W 910 x D 445 x H 190
mm
34.80 kg
EN