Adjust Baudrate; Inserting Paper; Attaching The Printer - Mettler Toledo RS-P42 Instrucciones De Manejo

Important
• Before operating, check all cables for damage.
• Guide the cables so that they cannot become damaged or interfere with the weigh-
ing process!
• Take care that the AC adapter cannot come into contact with liquids!
• The power plug must be always accessible.
2.3

Adjust baudrate

1
2
RS-P42 Printer
1 2
DTS-2
2.4

Inserting paper

2.5

Attaching the printer

• Open cover of paper compartment (1) and remove paper roll.
• Press plastic tab (2) backward and open the compartment
cover.
Baudrate
1200/8/N/None
2400/7/E/None
Important: To ensure that special characters (e.g. "ºC") are
printed out correctly on METTLER TOLEDO printers, the balance
and printer must be set to 1200/8/N/None.
• Feed paper through the slot in the printing unit in the direction
of the arrow.
• Switch on printer with toggle switch at the rear.
• Press and hold until sufficient paper has been fed in.
• Attach connection cable of the RS-P42 to the printer interface
of the instrument and to the printer.
After configuring the attached instrument for the RS-P42, the
printer is ready for operation.
Dip-Switch
1 2
on off
off off (Factory setting)
RS-P42 Printer 5