Troubleshooting; Important Safety Instructions - Kasanova MAS026823 Manual De Instrucciones

AROMA DIFFUSER
8

TROUBLESHOOTING

Please refer to the table below in the event of the product operating abnormally.
Symptoms
Will not switch
on or switch
off early
No mist or
abnormal mist

IMPORTANT SAFETY INSTRUCTIONS

Instructions pertaining to the risk of fire, electric shock, or injury to persons
WARNING-When using electrical products, basic precautions should always
be followed, including the following:
a) Read all the instructions before using the product.
b) To reduce the risk of injury, a close supervision is necessary when a
product is used near children and/or pets.
c)Do not put fingers or hands into the product while it is operating or plugged
in.
1.Place the Ultrasonic Oil Diffuser on a stable surface so it cannot be tipped
over.
Never allow the cord to hang over a counter edge or table, or to touch any hot
surface.
Failure to use as directed could cause damage, injury or fire.
2.The Ultrasonic Oil Diffuser is not a toy and should be kept out of reach of
children and pets to prevent serious injury.
3 Never cover the diffuser or block the spray nozzle while in use. This will
damage the unit.
4 The plug on the electric cord is intended for Ultrasonic Oil Diffuser purposes
only. Never add or modify electrical parts, as fire or dangerous electrical
shocks could result.
5.Unplug the appliance when not in use, when refilling or cleaning.
6.Not for outdoor use.
7.Never plug the Ultrasonic Oil Diffuser in with a wet hand or a wet cord.
Possible Cause
• Is there enough water in the
tank?
• Are the power cables
connected properly?
• Not enough water?
• Too much water?
• Dirt on the ultrasonic plate?
• Inner shell and outer shell are
not installed properly?
• Dirt on the air suction port on
the underside of the base?
Solution
• Add water to the tank.
• Disconnect, check cables and re-con-
nect carefully.
• Add amount of water in the tank.
• Water must never be filled over
600ML(MAX) line.
• Please refer to maintenance in-
structions, remove or reinstall them cor-
rectly, so the vapours can be released
freely.
• Clean the air suction port.
• Reduced airflow will affect mist.