Setup Mode; Setup Options; Entering Or Exiting Setup; Changing A Setup Option - SKF TKDT 10 Instrucciones De Uso

7. Setup mode

Use the Setup Mode to change different parameters.
The thermometer stores the settings in its memory.

7.1 Setup options

Option
Type
Offset
Sleep Mode

7.2 Entering or Exiting Setup

When the thermometer is in Setup mode, the display shows SETUP.
Set
Press button for 3 seconds to enter or exit Setup mode.

7.3 Changing a Setup Option

1. Press or
HOLD
2. Press to indicate that you want to change this setting.
Enter
3. Press or
HOLD
display.
4. Press to store the new setting in memory.
Enter
Note:
Setup is disabled in MAX/MIN mode.

7.4 Offset correction

Use the offset option in Setup to adjust the thermometer's readings
to compensate for the errors of a specific thermocouple.
The allowable adjustment range is ±5,0 °C or ±9.0 °F.
1. Plug the thermocouple into the input connector TI or T2.
2. Place the thermocouple in a known, stable temperature environment
3. Allow the readings to stabilize.
4. In Setup Mode change the offset until the top reading matches the
calibration temperature.

7.5 Auto Power Off

The thermometer will automatically switch off after 20 minutes if no
button is pressed during this time.
In Setup mode:
Press or MAX
MIN
HOLD
"On" or "OFF". Press
appears on the display.
Press to store the new setting in memory.
Enter
On (sleep mode on) or 0FF (sleep mode off).
8
Menu item
TYPE
OFFSET
SLP
to scroll to the setup option you want to change.
MAX
MIN
until the setting you want to use appears on the
MAX
MIN
to scroll to the "SLP" page. Press
or
MAX
MIN
HOLD
Settings
K
T1 or T2
On (sleep mode on) or
0FF (sleep mode off)
until the setting you want to use
to indicate
Enter
SKF TKDT 10