Zanussi ZDV 14001FA Manual De Instrucciones página 20

Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode, refer to 'Setting and starting a
programme'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) start to flash.
3. Press function button (A).
• The indicators of function buttons (B)
and (C) go off.
• The indicator of function button (A) con-
tinues to flash.
• Intermittent acoustic signals operate and
the end indicator flashes showing the
current setting of the water softener.
– The number of flashes of the end indi-
cator and the number of the acoustic
signals show the level of the water
softener.
E.g. 5 acoustic signals and 5 flashes +
pause + 5 acoustic signals and 5
flashes = level 5.
4. Press function button (A) again and again
to change the setting. Each time you press
function button (A) you go to the next level.
5. Deactivate the appliance to confirm the set-
ting.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it. Risk
20
2
Turn the water hard-
ness dial to the posi-
tion 1 or 2.
of corrosion. To prevent it, after you fill the salt
container, start a programme.
1
3
Put 1 litre of water in
the salt container (on-
ly for the first time).
5
Filling the rinse aid dispenser
1
2
4
6
2
www.zanussi.com